Make-noise Optomix Manuale Utente Scaricare il pdf (Pagina 8)

Patch Ideas

The New Bongo:

Set up a VCO for two-operator FM by applying a SINE wave to its linear FM input, and patch it to the input of

an Optomix. Patch Pressure Points Common Gate OUT to the Optomix Strike Input, and Gate OUT 3 to the

DAMP input. Strike the “Bongo” with Touchplate 4 and “dampen” it during or after striking with touchplate 3.

Use the DAMP input attenuator to set the amount of damping.

Optional: use one or more of the Pressure outputs to the Control and/or DAMP input on the Optomix for

more fine control.

FM Pings:

Patch an FM source such as an audio-rate SINE wave to Optomix Ch1 INput. Patch Ch1 OUTput to the

Linear FM input on STO, or another VCO of your choice. Adjust Optomix Control full CCW (0%). Patch a

trigger or gate source to Optomix STRIKE input to “ping” the destination VCO with a short burst of FM.

Adjust DAMP control to taste.

Optional: Dynamically control the FM Pings by setting up the patch as above with Ch1, applying a slow

MATHS or Function Cycle (or any positive-going control voltage) to Ch2 Control Input, and patching the

Optomix SUM Out to the VCO’s FM input.

1 2 3 4 5 6 7 8

Nessun commento

Make-noise Optomix Manuale Utente Pagina 8